Exam 200-105 topic 1 question 354 discussion

Actual exam question from Cisco's 200-105

Question #: 354
Topic #: 1

Refer to the exhibit. A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1.
The configurations of the hosts have been verified as correct. What is the cause of the problem?

A. The serial cable on R1 needs to be replaced.
B. The interfaces on R2 are not configured properly.
C. R1 has no route to the 192.168.1.128 network.
D. The IP addressing scheme has overlapping subnetworks.
E. The ip subnet-zero command must be configured on both routers. C

Show Suggested Answer

Suggested Answer: Explanation 🗳️
Whenever a node needs to send data to another node on a network, it must first know where to send it. If the node cannot directly connect to the destination node, it has to send it via other nodes along a proper route to the destination node. A remote network is a network that can only be reached by sending the packet to another router. Remote networks are added to the routing table using either a dynamic routing protocol or by configuring static routes. Static routes are routes to networks that a network administrator manually configured. So R should have static route for the 192.168.1.128.

by bitsuspect at April 4, 2019, 11:39 a.m.

Comments

Submit Cancel

bitsuspect

5 years, 8 months ago

The correct answer is C

upvoted 2 times

icdaniel

4 years, 10 months ago

Yes, the answer is at the end of option D.

upvoted 1 times

...

Exam 200-105 All Questions

View all questions & answers for the 200-105 exam

Exam 200-105 topic 1 question 354 discussion

Comments

bitsuspect

icdaniel

SY0-701