To add to this on why B is correct. I wanted to double check one more thing. When configuring a tap or tool port, you have to enable "switchport mode "tap/tool" when doing this after entering one of the other, there is no more avaialble commands you get the <cr> when entering switchport mode tool ?.. So A is definitely not correct.
B is correct, if it is assumed these ports have been enabled for tap and tool mode using switchport mode tap/tool command. This is a requirement. To double check this, I verified my span switch configuration and all tap and tool ports have switchport mode tap/tool entered.
This section is not available anymore. Please use the main Exam Page.ACE-A1.2 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
network_guru
1 year, 3 months agonetwork_guru
1 year, 3 months agoVelillatom11
1 year, 7 months agowanght123
1 year, 6 months agowanght123
1 year, 6 months ago