ExamTopics Logo
Mail Us[email protected]
Menu
Checkpoint Discussions
exam questions

Exam 156-215.80 All Questions

View all questions & answers for the 156-215.80 exam
Go to Exam

Exam 156-215.80 topic 1 question 267 discussion

Actual exam question from Checkpoint's 156-215.80
Question #: 267
Topic #: 1
[All 156-215.80 Questions]

Which command can you use to enable or disable multi-queue per interface?

  • A. cpmq set
  • B. Cpmqueue set
  • C. Cpmq config
  • D. Set cpmq enable
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
Reference:
https://sc1.checkpoint.com/documents/R76/CP_R76_PerformanceTuning_WebAdmin/93689.htm
by Nikolas at May 7, 2020, 4:54 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
babochnik
8 months, 1 week ago
Selected Answer: A
In R80.30: cpmq set In R80.40 adn above: set interface eth2 multi-queue {off | auto | manual} https://sc1.checkpoint.com/documents/R80.30/WebAdminGuides/EN/CP_R80.30_CLI_ReferenceGuide/html_frameset.htm?topic=documents/R80.30/WebAdminGuides/EN/CP_R80.30_CLI_ReferenceGuide/206539 https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk153373#TARGET_CLISH_EXAMPLES
upvoted 1 times
...
itsallenadrian
1 year, 3 months ago
Is this a part of CCSA R80 Exam?
upvoted 1 times
...
kambata
2 years, 2 months ago
Another CCSE
upvoted 3 times
...
Nikolas
2 years, 4 months ago
from CCSE R80 guide: Use the following command to configure Multi-Queue on supported interfaces: cpmq set
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel