Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from Linux1 on Switch1 to Linux2 on Switch2. Which command must be added to the destination configuration to enable the ERSPAN tunnel?
A.
(config-mon-erspan-src-dst)# no shut
B.
(config-mon-erspan-src-dst)# traffic bidirectional
C.
(config-mon-erspan-src-dst)# monitor session 1 activate
D.
(config-mon-erspan-src-dst)# ip address 10.10.10.10
There are 2 versions of this question.
Version 1, missing item:
Switch2(config-mon-erspan-dst-src)# erspan-id 110
Version 2, missing item:
Switch1(config-mon-src-dst) ip address 10.10.10.10
- You must specify the destination IP address for the ERSPAN traffic in the source session config
- ERSPAN flow ID must match in source and destination sessions.
I approve the answer, what is needed:
- Unique session ID
- List of source interfaces or source VLANs that you want to monitor
- What traffic we want to capture: tx, rx or both
- Destination IP address for the GRE tunnel
- Origin IP address which is used as the source for the GRE tunnel
- Unique ERSPAN flow ID
This section is not available anymore. Please use the main Exam Page.350-401 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
AbdullahMohammad251
8 months, 4 weeks agoMike_93
11 months, 2 weeks ago[Removed]
1 year agoslacker_at_work
1 year, 3 months agoAsombrosso
1 year, 9 months agoDoh247
2 years, 3 months agosnarkymark
2 years, 3 months ago