Exam 300-620 topic 1 question 174 discussion

Actual exam question from Cisco's 300-620

Question #: 174
Topic #: 1

Refer to the exhibit. A company decided to decrease its routing footprint and remove RT-2 and RT-3 devices from its data center. Because of that, the exit point must be created from all the tenants by using the common tenant. Which two configuration tasks must be completed to meet these requirements? (Choose two.)

A. Move subnets from all the bridge domains to the EPG level and mark them with flag Shared between VRFs.
B. Update the L3Out ExtEPG subnet in the common tenant with flag Shared Route Control Subnet and Aggregate Shared Routes.
C. Mark all subnets with flag Shared between VRFs and attach contract Ctr-3 as a provider to all the EPGs.
D. Change contract Ctr-3 scope to Global, consume it by all EPGs, and flag all subnets with flag Shared between VRFs.
E. Export contract Ctr-2 into the tenant TN-1 and attach it as a consumer to all the EPGs in the tenant TN-1.

Show Suggested Answer

Suggested Answer: BD 🗳️

by frzzt at March 16, 2023, 12:20 p.m.

Comments

Submit Cancel

Mr_Certifiable

6 months, 1 week ago

BD - . Configure your VRF, Bridge Domains (BDs) and subnets under each user Tenant. Associate Bridge Domains (BDs) with the VRF in User tenants. 1. Ensure the BDs are marked as both “advertised externally and shared.” 2. Configure the Application Profile(s) under each user Tenant. 3. Under each user Tenant, configure EPG and associate EPG with the BD configured in step 1 4. Consume the contract from Tenant Common https://www.cisco.com/c/dam/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/aci-configuring.pdf

upvoted 2 times

...

Rododendron2

7 months ago

Selected Answer: BD

same tip here, BD is correct.

upvoted 1 times

...

frzzt

8 months, 3 weeks ago

Selected Answer: BD

BD is correct.

upvoted 2 times

...