Refer to the exhibit. An engineer must configure DMVPN Phase 3 hub-and-spoke topology to enable a spoke-to-spoke tunnel. Which NHRP configuration meets the requirement on R6?
A.
interface Tunnel1 ip nhrp authentication Cisco123 ip nhrp map multicast dynamic ip nhrp network-id 1 ip nhrp holdtime 300 ip nhrp redirect
B.
interface Tunnel 1 ip address 192.168.1.1 255.255.255.0 tunnel source e 0/1 tunnel mode gre multipoint ip nhrp network-id 1 ip nhrp map 192.168.1.2 192.1.20.2
C.
interface Tunnel1 ip nhrp authentication Cisco123 ip nhrp map multicast dynamic ip nhrp network-id 1 ip nhrp holdtime 300 ip nhrp shortcut
D.
Interface Tunnel 1 ip address 192.168.1.1 255.255.255.0 tunnel source e 0/0 tunnel mode gre multipoint ip nhrp network-id 1
Is it not required to add the command “tunnel mode gre multipoint “ on the hub router
upvoted 2 times
...
This section is not available anymore. Please use the main Exam Page.300-410 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
HungarianDish_111
Highly Voted 2 years agoHarwinderSekhon
Highly Voted 1 year, 9 months ago[Removed]
Most Recent 10 months agoColmenarez
1 year, 8 months ago[Removed]
1 year, 9 months ago