ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 200-301 All Questions

View all questions & answers for the 200-301 exam
Go to Exam

Exam 200-301 topic 1 question 1111 discussion

Actual exam question from Cisco's 200-301
Question #: 1111
Topic #: 1
[All 200-301 Questions]



Refer to the exhibit. SW2 is replaced because of a hardware failure. A network engineer starts to configure SW2 by copying the fa0/1 interface configuration from SW1. Which command must be configured on the fa0/1 interface of SW2 to enable PC1 to connect to PC2?

  • A. switchport mode trunk
  • B. switchport trunk native vlan 10
  • C. switchport mode access
  • D. switchport trunk allowed remove 10
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by Bhrino at May 15, 2023, 10:21 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Bhrino
Highly Voted 2 years, 1 month ago
Selected Answer: A
have to tell the switch that the specific interface is a trunk port ie A
upvoted 8 times
...
adrianspa
Most Recent 10 months, 1 week ago
Selected Answer: A
Don't get tricked by option B as the PCs reside on VLAN 5 not VLAN 10
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel