During a boot process of a Cisco UCS C-Series Rack Server, an engineer receives a “No Signal” message from the vKVM and physical video connection. Which set of steps resolves the issue?
A.
1. Disconnect the power cord. 2. Confirm that all cards are properly seated. 3. Connect the power cord and power on the server.
B.
1. Power off the server and disconnect the power cord. 2. Confirm that all cards are properly seated. 3. Connect the power cord and power on the server.
C.
1. Disconnect the power cord. 2. Confirm that all cards are properly seated. 3. Connect the power cord.
D.
1. Power off the server and disconnect the power cord. 2. Confirm that all cards are available. 3. Connect the power cord and power on the server.
Answer is A
“No Signal” on vKVM and Physical Video Connection
If immediately at boot you receive a “No Signal” message from the vKVM and physical video connection,
the PCI riser card might not be properly seated to the motherboard. To resolve the issue, complete these steps:
Procedure
Step 1 Power off the server and disconnect the power cord.
Step 2 Confirm that all cards are properly seated.
Step 3 Connect the power cord and power on the server.
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-615 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
NOLUCK
11 months agoNOLUCK
11 months, 1 week ago