Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.)
A.
Configure the local vPC role priority to have a lower value than Switch-A.
B.
Configure the local vPC role priority to have a higher value than Switch-A.
C.
Disable and then re-enable the vPC peer-keepalive link.
D.
Configure the local vPC role priority to have the same value as Switch-A.
You can also use role priority in vPC domain mode command to influence vPC Election process. The range of values is from 1 to 65636, and the default value is 32667. A lower value means that this switch has a better chance to be the primary vPC.
When you change the priority of the vPC peer devices, it can cause the interfaces in your network to go up and down. If you want to configure the role priority again to make one vPC device the primary device, configure the role priority on both the primary vPC device with a lower priority value and the secondary vPC device with the higher value. Then, shut down the vPC peer link on both devices and enter the shutdown command, and finally re-enable the port-channel on both devices and enter the no shutdown command.
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-615 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
[Removed]
8 months, 2 weeks agoparadigm88
1 year, 10 months ago