ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-615 All Questions

View all questions & answers for the 300-615 exam
Go to Exam

Exam 300-615 topic 1 question 73 discussion

Actual exam question from Cisco's 300-615
Question #: 73
Topic #: 1
[All 300-615 Questions]







Refer to the exhibit. A network engineer must use BGP to route IPv4 and IPv6 routes between R1 and R2. The IPv4 addresses are exchanged as expected between the routers through BGP. The routers have reached an Established BGP state. However, the IPv6 routes from R2 fail to show in the routing table of R1. Which action resolves the issue?

  • A. Enable IPv6 routing on R1.
  • B. Create a route map that sets the IPv6 next hop.
  • C. Configure an IPv6 BGP neighbor on R1.
  • D. Advertise L2VPN EVPN under IPv4 unicast address family.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by paradigm88 at July 7, 2023, 8:24 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
paradigm88
10 months ago
Answer B would be a PBR. shouldn't be C ? Anyway the exhibit shows ipv6 routes learned from R2 ? or i don't understand the question
upvoted 1 times
paradigm88
10 months ago
B is correct https://community.cisco.com/t5/networking-knowledge-base/advertising-ipv6-prefixes-routes-over-ipv4-ebgp-peers/ta-p/3130696
upvoted 1 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago