ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-101 All Questions

View all questions & answers for the 300-101 exam
Go to Exam

Exam 300-101 topic 1 question 577 discussion

Actual exam question from Cisco's 300-101
Question #: 577
Topic #: 1
[All 300-101 Questions]

Refer to the exhibit.

How would you confirm on R1 that load balancing is actually occurring on default-network (0.0.0.0)?

  • A. Use ping and the show ip route command to confirm the timers for each default network resets to 0
  • B. Load balancing does not occur over default networks; the second route will only be used for failover.
  • C. Use an extended ping along with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.
  • D. Use the traceroute command to an address that is not explicitly in the routing table. D
Show Suggested Answer Hide Answer
Suggested Answer: Explanation 🗳️
The simplest method to test load balancing is to use the "traceroute" command. If load balancing is working correctly, we will see different paths to reach the destination each time we use that command.
Unknown address will be routed via the default-network 0.0.0.0 so we must use an address that is not explicitly in the routing table.
by soon at Jan. 6, 2020, 10:38 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
soon
5 years, 5 months ago
D. Use the traceroute command to an address that is not explicitly in the routing table.
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel