ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-430 All Questions

View all questions & answers for the 300-430 exam
Go to Exam

Exam 300-430 topic 1 question 202 discussion

Actual exam question from Cisco's 300-430
Question #: 202
Topic #: 1
[All 300-430 Questions]

A network engineer is configuring a Cisco AireOS 8.2 WLC, Cisco MSE, and Cisco PI with Cisco 3700 Series APs and Cisco Hyperlocation modules. The engineer configures and enables a WLAN with Hyperlocation. During testing, the engineer notices that the Hyperlocation module cannot be seen on the WLC. Which action resolves the issue?

  • A. Configure the APs to be in monitor mode.
  • B. Enable Hyperlocation in the Global Configuration settings of the WLC.
  • C. Add the key hash that is used to add the Hyperlocation module to the WLC.
  • D. Enable the NTP server that is connected to the Hyperlocation module.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by GoldLeader at July 16, 2023, 8:05 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
ce1997d
7 months, 4 weeks ago
Selected Answer: B
HyperLocation module cannot be seen on the WLC Ensure the correct AP type is used for deployment. Ensure the correct software code is installed for the WLC that supports the HyperLocation module deployment. Ensure HyperLocation is enabled on the WLC global configuration settings. Ensure HyperLocation Module is plugged in right and screws are tight. Ensure that the AP is not in monitor mode. Ensure the correct recommended bracket (AIR-AP-BRACKET-2) is used to install the AP and Module combination.
upvoted 1 times
...
laputaxu
1 year, 9 months ago
More source https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_hyperLocation_best_practices_and_troubleshooting_guide.html#id_12821
upvoted 3 times
...
Vlad_Is_Love_ua
1 year, 9 months ago
Selected Answer: B
Step 1 Choose Wireless > Access Points > Global Configuration. Step 2 In the Hyperlocation Config Parameters section: Check the Enable Hyperlocation check box. Based on AP and installed module, checking the Enable Hyperlocation check box enables different location service (PRL-based or AoA-based). https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-2/config-guide/b_cg82/b_cg82_chapter_011010.html#config-hyperlocation-global:~:text=Check%20the%20Enable%20Hyperlocation%20check%20box.
upvoted 4 times
...
GoldLeader
1 year, 9 months ago
Selected Answer: B
Correct answer should be B. Wireless --> Access Points --> Global Configuration --> Enable Hyperlocation checkbox.
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago