An engineer must enable AVC on a Cisco Catalyst 9800 WLC and send the NetFlow data to a NetFlow collector. What must be configured on the controller with the IP address and port number of the NetFlow collector?
To enable Application Visibility and Control (AVC) on a Cisco Catalyst 9800 Wireless LAN Controller (WLC) and send NetFlow data to a NetFlow collector, you must configure a flow exporter. The flow exporter specifies the IP address and port number of the NetFlow collector where the data will be sent.
Explanation of the options:
A. flow exporter: This is correct. The flow exporter is used to define the destination (IP address and port) of the NetFlow collector.
B. flow policy: A flow policy is used to define actions (e.g., marking, policing) applied to traffic flows, but it does not specify the NetFlow collector's IP address and port.
C. flow monitor: A flow monitor is used to associate a flow record with an interface to collect traffic data, but it does not specify the NetFlow collector's IP address and port.
D. flow record: A flow record defines the specific traffic attributes (e.g., source IP, destination IP, protocol) to be collected, but it does not specify the NetFlow collector's IP address and port.
This section is not available anymore. Please use the main Exam Page.300-430 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
rrahim
2 months, 2 weeks agoSeba_o_s
5 months, 2 weeks agokejvi
8 months, 3 weeks ago