Exam 350-401 topic 1 question 795 discussion

Actual exam question from Cisco's 350-401

Question #: 795
Topic #: 1

Refer to the exhibit. A network engineer is troubleshooting an issue with the file server based on reports of slow file transmissions. Which two commands or command sets are required to switch SW1 to analyze the traffic from the file server with a packet analyzer? (Choose two.)

A. SW1#show monitor
B. SW1(config)#monitor session 1 source interface gigabitethernet0/3
SW1(config)#monitor session 1 destination interface gigabitethernet0/1 encapsulation replicate
C. SW1#show ip route
D. SW1#show vlan
E. SW1(config)#monitor session 1 source interface gigabitethernet0/1
SW1(config)#monitor session 1 destination interface gigabitethernet0/3 encapsulation replicate

Show Suggested Answer

Suggested Answer: AB 🗳️

by blitzstorm at Sept. 6, 2023, 7:33 p.m.

Comments

Submit Cancel

blitzstorm

Highly Voted 1 year, 9 months ago

Selected Answer: AB

Given answer is correct.

upvoted 6 times

...

NetworkJanitor

Most Recent 7 months ago

Selected Answer: A

It's A. Fell for E so watch your flow direction. See the options (code 17.x): CAT9-UADP_1(config)#$tination interface gigabitEthernet 0/0 encapsulation ? dot1q interface uses only dot1q encapsulation replicate interface replicates source encapsulation <----copies to sniffer/pcap pc CAT9-UADP_1(config)#$tination interface gigabitEthernet 0/0 encapsulation re CAT9-UADP_1(config)#$nterface gigabitEthernet 0/0 encapsulation replicate ? ingress Enable ingress traffic forwarding <cr> <cr> hth

upvoted 2 times

...

[Removed]

1 year ago

Selected Answer: AB

A and B ar correct

upvoted 1 times

...