ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 200-125 All Questions

View all questions & answers for the 200-125 exam
Go to Exam

Exam 200-125 topic 2 question 80 discussion

Actual exam question from Cisco's 200-125
Question #: 80
Topic #: 2
[All 200-125 Questions]

What is one requirement for interfaces to run IPv6?

  • A. An IPv6 address must be configured on the interface.
  • B. An IPv4 address must be configured.
  • C. Stateless autoconfiguration must be enabled after enabling IPv6 on the interface.
  • D. IPv6 must be enabled with the ipv6 enable command in global configuration mode.
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
To use IPv6 on your router, you must, at a minimum, enable the protocol and assign IPv6 addresses to your interfaces.
by Paradox at Jan. 15, 2020, 3:57 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Paradox
5 years, 5 months ago
Sorry A is correct miss read the Question
upvoted 2 times
...
Paradox
5 years, 5 months ago
Ans should be D
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel