ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 200-105 All Questions

View all questions & answers for the 200-105 exam
Go to Exam

Exam 200-105 topic 2 question 37 discussion

Actual exam question from Cisco's 200-105
Question #: 37
Topic #: 2
[All 200-105 Questions]

Which command do you enter to permit IPv6 functionality on an EIGRPv3 interface?

  • A. Router1(config)#ipv6 unicast-routing
  • B. Router1(config-if)#ipv6 router eigrp 1
  • C. Router1(config-if)#ipv6 enable
  • D. Router1(config-if)#ipv6 eigrp 1
Show Suggested Answer Hide Answer
Suggested Answer: D 🗳️
Reference:
https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/113267-eigrp-ipv6-00.html
by darratt at Jan. 26, 2020, 10:26 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
immz
5 years, 5 months ago
correct answer is D
upvoted 2 times
...
darratt
5 years, 5 months ago
B. Router1(config-if)#ipv6 router eigrp 1 Answer B
upvoted 4 times
vladut
5 years, 5 months ago
B sets the asn for router to conf the r id and for interface its D
upvoted 1 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel