Exam 200-301 topic 1 question 1204 discussion

Actual exam question from Cisco's 200-301

Question #: 1204
Topic #: 1

Refer to the exhibit. An administrator must connect SW_1 and the printer to the network. SW_2 requires DTP to be used for the connection to SW_1. The printer is configured as an access port with VLAN 5. Which set of commands completes the connectivity?

A. switchport mode dynamic auto
switchport private-vlan association host 5
B. switchport mode trunk
switchport trunk pruning vlan add 5
C. switchport mode dynamic desirable
switchport trunk allowed vlan add 5
D. switchport mode dynamic auto
switchport trunk encapsulation negotiate

Show Suggested Answer

Suggested Answer: C 🗳️

by CCNA_slayer at Dec. 10, 2023, 10:09 a.m.

Comments

Submit Cancel

AbdullahMohammad251

Highly Voted 9 months, 2 weeks ago

* SW2 Et0/2 is configured with dynamic auto mode. Interface (Et0/2) of SW1 should be configured in either trunk or dynamic desirable mode to establish a trunk link. * The "Pruning VLAN" command is the opposite of the "allowed VLAN" command, it excludes certain VLANs from being allowed on a trunk link. Option A is incorrect, mode can't be auto Option B is incorrect, mode is correct, but "switchport allowed vlan add 5" command should be used instead. Option C is correct option D is incorrect. The mode must be set to dynamic desirable or trunk

upvoted 5 times

...

[Removed]

Most Recent 8 months ago

Selected Answer: C

C is correct

upvoted 1 times

...

CCNA_slayer

12 months ago

Selected Answer: C

C is correct

upvoted 3 times

...