Refer to the exhibit. A network engineer configures the CCNA WLAN so that clients must reauthenticate hourly and to limit the number of simultaneous connections to the WLAN to 10. Which two actions complete this configuration? (Choose two.)
A.
Enable the Wi-Fi Direct Clients Policy option
B.
Enable the Enable Session Timeout option and set the value to 3600.
C.
Enable the Client Exclusion option and set the value to 3600.
D.
Set the Maximum Allowed Clients value to 10.
E.
Set the Maximum Allowed Clients Per AP Radio value to 10.
To configure the CCNA WLAN to require clients to reauthenticate hourly and to limit the number of simultaneous connections to 10, the network engineer should:
B. Enable the Enable Session Timeout option and set the value to 3600.
This setting will require clients to reauthenticate after one hour (3600 seconds).
D. Set the Maximum Allowed Clients value to 10.
This will limit the total number of clients that can connect to the WLAN to 10.
These actions correspond with the typical settings found in WLAN configurations on network controllers for session timeout and client limitations.
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.200-301 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
fadeniyi
Highly Voted 10 months, 3 weeks ago[Removed]
Most Recent 7 months agolmmujsi
7 months ago