Refer to the exhibit. While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?
A.
Modify the IP address or mask of the interface to a valid one
B.
Set up a priority different than 0 in the interface
C.
Modify the router ID to be the interface IP on the serial
Default Network Type on Serial is non-broadcast so setting it point-to-point cannot work. The IP 172.16.1.0/32 is not correct, that does not allow it to communicate with anything.
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-510 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
thejag
10 months, 3 weeks ago