ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 210-060 All Questions

View all questions & answers for the 210-060 exam
Go to Exam

Exam 210-060 topic 1 question 311 discussion

Actual exam question from Cisco's 210-060
Question #: 311
Topic #: 1
[All 210-060 Questions]

The microphone on a Cisco TelePresence System 3000 is switching incorrectly to a camera that does not have an active speaker. What is the first step that an engineer should take to troubleshoot this issue?

  • A. Check whether the microphone is properly plugged in.
  • B. Check whether the cable from the microphone is plugged into the correct receptor on the codec.
  • C. Run the microphone calibration procedure.
  • D. Plug all microphones into the primary codec.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by MarkusW at Feb. 3, 2020, 8:41 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
MarkusW
5 years, 5 months ago
C is correct. In the calibration process you see the incorrect cabling and can correct this.
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel