ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-620 All Questions

View all questions & answers for the 300-620 exam
Go to Exam

Exam 300-620 topic 1 question 247 discussion

Actual exam question from Cisco's 300-620
Question #: 247
Topic #: 1
[All 300-620 Questions]

An engineer configures an L3Out between BLeaf1 and Core1. A Cisco Nexus 9000 Series Switch runs in NX-OS mode, and the two devices must peer using OSPF. The devices in the network are configured as follows:

• BLeaf1 has been configured with the IP address 10.1.0.2/31 and the router ID 0.0.0.2.
• Core1 has been configured with the IP address 10.1.0.3/31 and the router ID 0.0.0.1.
• On Cisco ACI, the engineer has enabled OSPF using the default OSPF settings.
• The engineer has configured OSPF on the NX-OS switch using the ip router ospf ACI_peering area 1 command.

Which action brings up the OSPF adjacency?

  • A. Set and Auth Key on Core1.
  • B. Configure Area 1 on BLeaf1.
  • C. Disable Hello Timer on BLeaf1.
  • D. Change the MTU on Core1.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by ed27 at Feb. 17, 2024, 10:21 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
SvelterPrice97
6 days, 13 hours ago
Selected Answer: D
I'm ok with prospio971, and think it's D. Tested in ACI lab by default the area is set to 1, so maybe it's the MTU (Not clear as always with this f*** type of question)
upvoted 1 times
...
prospio971
2 months, 3 weeks ago
Selected Answer: D
In OSPF, mismatched MTU settings between two devices can prevent the OSPF adjacency from forming. By default, Cisco Nexus 9000 switches in NX-OS mode perform an MTU check during the OSPF adjacency negotiation process. If the MTU values on the interfaces of BLeaf1 and Core1 do not match, the adjacency will fail to establish. To resolve this issue, you need to ensure that both devices have matching MTU settings. Changing the MTU on Core1 to match BLeaf1 will allow the OSPF adjacency to form successfully. This is a common troubleshooting step when dealing with OSPF adjacency issues caused by MTU mismatches.
upvoted 3 times
...
ed27
8 months, 2 weeks ago
Selected Answer: B
B is correct
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago