exam questions

Exam 300-410 All Questions

View all questions & answers for the 300-410 exam

Exam 300-410 topic 1 question 538 discussion

Actual exam question from Cisco's 300-410
Question #: 538
Topic #: 1
[All 300-410 Questions]



Refer to the exhibit. The 130.130.130.0/24 route shows in the R2 routing table but is getting filtering toward R3. Which action resolves the issue?

  • A. Automatic route summarization must be enabled on R2.
  • B. The outgoing filter list for all interfaces must be set on R2.
  • C. The incoming filter list for all interfaces must be set on R2.
  • D. IGP synchronization must be disabled on R2.
Show Suggested Answer Hide Answer
Suggested Answer: D 🗳️

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
DavideDL
Highly Voted 1 year, 2 months ago
Selected Answer: D
BGP synchronization is an old rule from the days when we didn’t run IBGP on all routers within a transit AS. In short, BGP will not advertise something that it learns from an IBGP neighbor to an EBGP neighbor if the prefix can’t be validated in its IGP.
upvoted 9 times
...
Bombbear_W
Highly Voted 1 year, 2 months ago
Selected Answer: D
The answer is D https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/19345-bgp-noad.html Scroll down to the "Unable to Announce iBGP-Learned Routes" section for the explaination.
upvoted 8 times
Commando1664
1 year, 2 months ago
I did and it is actually this diagram hahaha!
upvoted 3 times
...
...
cutetruck
Most Recent 3 months, 1 week ago
Selected Answer: D
D is correct IGP synchronization only allows the router to advertise IBGP routes if its able to validate the route from an IGP. Since no IGP is currently running based on the "show ip protocols" output, we need to disable IGP synchronization.
upvoted 2 times
...
[Removed]
9 months, 2 weeks ago
Selected Answer: D
D is corerct
upvoted 1 times
...
Pietjeplukgeluk
10 months ago
Selected Answer: D
After some reading I agree, you should DISABLE IGP synchronistation requirement using "no synchronization" under the "router bgp ..."
upvoted 3 times
Pietjeplukgeluk
10 months ago
note "no synchronistation" is actually the default
upvoted 1 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
Loading ...
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago