Exam 200-301 topic 1 question 1339 discussion

A is correct By setting the port-channel min-links to 2, the switch ensures that the port-channel interface will only remain operational if at least 2 physical links in the bundle are active and functioning. If the both 2 links ge0/0 AND ge0/1 on SW2 goes down, the overall link count drops below the configured minimum (2), causing the port-channel to go down as well.

A. SW2# configure terminal - SW2(config)# interface port-channel 1 SW2(config-if)# port-channel min-links 2 This command sets the minimum number of links that must be up in the port-channel for it to stay active to 2. If both ports go down, the EtherChannel will be disabled, which is the desired outcome according to the scenario presented. Please note that the port-channel number should match the actual port-channel being configured, which is 1 according to the exhibit, not 4 as indicated in the answer choices. This is likely a typo in the provided answer options.

This is not a CCNA question. This is a CCNP question.

please revised my answer, it should be C,

A is correct

A is correct.

According to this documentation, the answer is A. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/release/17-2/configuration_guide/lyr2/b_172_lyr2_9200_cg/configuring_etherchannels.html#id_97595

A The port-channel min-links command specifies the minimum number of interfaces that the configuration mode LAG requires to be active

Option C Option C: lacp max-bundle 2 sets the maximum number of links that can be bundled into port channel 1. This option effectively disables the port channel when only one or no links are available, which aligns with the desired behavior of disabling the channel when both Ge0/0 and Ge0/1 are down