Due to a shortage of physical interfaces on a device, the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
A.
voice-class sip early-offer forced
B.
voice-class sip bind control source-interface Loopback0
C.
voice-class sip bind media source-interface Loopback0
D.
voice-class sip resource priority mode passthrough
Configuring SIP Binding
6. Use one of the following commands to configure SIP binding:
- voice-class sip bind media {source-address ipv4 ipv4-address | source-interface interface-id [ipv6-address ipv6-address]} in dial-peer configuration mode.
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/voi-sip-bind.html#GUID-89132FC8-B523-420B-A48F-0A5FC853E55A
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-815 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
1b9a51d
10 months ago