Exam 200-301 topic 1 question 1373 discussion

SIMULATION
-


Guidelines
-

This is a lab item in which tasks will be performed on virtual devices

• Refer to the Tasks tab to view the tasks for this lab item.
• Refer to the Topology tab to access the device console(s) and perform the tasks.
• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
• All necessary pre-configurations have been applied.
• Do not remove any existing configurations from the devices, only those necessary to make the appropriate changes required to fulfill the listed tasks.
• Do not change the enable password or hostname for any device.
• Save your configurations to NVRAM before moving to the next item.
• Click Next at the bottom of the screen to submit this lab and move to the next question.
• When Next is clicked, the lab closes and cannot be reopened.


Topology
-




Tasks
-


Task 1
-

Configure trunks between Sw1 and Sw2 on ports E0/0 and E0/1 using the IEEE standard frame tagging method.

• Add VLAN 99 as untagged on the trunk ports.
• Only extend VLAN 110 and the untagged VLAN across the trunk.
• Verify that PC1 is capable of pinging PC2.


Task 2
-

On Sw1 and Sw2, use IEEE 802.3ad link aggregation.

• Combine E0/0 and E0/1 into a single logical link while leaving the trunk configurations intact.
• Assign number 20 to the link.
• Both links must negotiate aggregation.

Suggested Answer: