Exam 300-620 topic 1 question 115 discussion

Actual exam question from Cisco's 300-620

Question #: 115
Topic #: 1

A network engineer is integrating a new Hyperflex storage duster into an existing Cisco ACI fabric. The Hyperflex cluster must be managed by vCenter, so a new vSphere Distributed switch must be created. In addition, the hardware discovery must be performed by a vendor-neutral discovery protocol. Which set of steps meets these requirements?

A. Configure an Interface Policy group, select CDP, and apply it to the desired interfaces.
Enter the vCenter IP and credentials in the Create vCenter Controller dialog box.
In the Create VMware VMM domain dialog box, select Read-Only Mode.
B. Configure an Interface Policy group, select LLDP, and apply it to the selected interfaces.
Create a VLAN pool, add it to the VMware VMM domain, and include the appropriate interfaces.
Enter the vCenter IP and credentials in the Create vCenter Controller dialog box.
C. Configure a Switch Policy group, select LLDP, and apply it to the indicated interfaces.
Set up a VMware VMM domain and apply it to the appropriate interfaces.
Enter the APIC management IP and credentials in the Create vCenter Controller dialog box.
D. Configure an Interface Policy group, select CDP, and apply it to the designated interfaces.
Create a VMware VMM domain, add it to the VLAN pool, and associate it to the designated interfaces.
Select Read Only Mode in the Create VMware VMM domain dialog box.

Show Suggested Answer

Suggested Answer: B 🗳️

by prospio971 at Jan. 30, 2025, 11:56 a.m.

Comments

Submit Cancel

prospio971

4 months, 3 weeks ago

Selected Answer: B

LLDP is the vendor-neutral discovery protocol that should be used for hardware discovery in this scenario, as it allows for the discovery of non-Cisco devices and is supported by both ACI and Hyperflex.

upvoted 2 times

...