ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 100-105 All Questions

View all questions & answers for the 100-105 exam
Go to Exam

Exam 100-105 topic 1 question 174 discussion

Actual exam question from Cisco's 100-105
Question #: 174
Topic #: 1
[All 100-105 Questions]

Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.)

Router(config)# router ospf 1 -

  • A. All OSPF routers in an area must have the same process ID.
  • B. Only one process number can be used on the same router.
  • C. Different process identifiers can be used to run multiple OSPF processes.
  • D. The process number can be any number from 1 to 65,535.
  • E. Hello packets are sent to each neighbor to determine the processor identifier.
Show Suggested Answer Hide Answer
Suggested Answer: CD 🗳️
Multiple OSPF processes can be configured on a router using multiple process ID's. The valid process ID's are shown below:
Edge-B(config)#router ospf ?
<1-65535> Process ID
by [deleted] at April 2, 2025, 2:53 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel