ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 100-105 All Questions

View all questions & answers for the 100-105 exam
Go to Exam

Exam 100-105 topic 1 question 177 discussion

Actual exam question from Cisco's 100-105
Question #: 177
Topic #: 1
[All 100-105 Questions]

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common
Ethernet link.

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?

  • A. The OSPF area is not configured properly.
  • B. The priority on R1 should be set higher.
  • C. The cost on R1 should be set higher.
  • D. The hello and dead timers are not configured properly.
  • E. A backup designated router needs to be added to the network.
  • F. The OSPF process ID numbers must match.
Show Suggested Answer Hide Answer
Suggested Answer: D 🗳️
In OSPF, the hello and dead intervals must match and here we can see the hello interval is set to 5 on R1 and 10 on R2. The dead interval is also set to 20 on R1 but it is 40 on R2.
by [deleted] at April 2, 2025, 2:53 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago