Exam 210-065 topic 5 question 69 discussion

Actual exam question from Cisco's 210-065

Question #: 69
Topic #: 5

[All 210-065 Questions]

Which three items should be considered when restoring a backup to a Cisco VCS Expressway? (Choose three.)

A. A restart is required to complete the system restore process.
B. If the backup file is encrypted, an encryption password will be needed.
C. A valid backup configuration file must be accessible.
D. A function SFTP server is needed for remote restore.
E. The VCS expressway must be put into maintenance mode during the upgrade.
F. A flash drive that is connected to the appliance can be used to restore the configuration.
G. Cisco TMSXE can be used to process and restore backups.

Show Suggested Answer

Suggested Answer: ABC 🗳️
Reference:
http://www.cisco.com/en/US/docs/voice_ip_comm/expressway/admin_guide/Cisco-Expressway-Administrator-Guide-X8-1.pdf

Exp: Creating a system backup -
1. Go to Maintenance > Backup and restore.
2. Optionally, enter an Encryption password with which to encrypt the backup file. If a password is specified, the same password will be required to restore the file.
3. Click Create system backup file.
4. After the backup file has been prepared, a pop-up window appears and prompts you to save the file (the exact wording depends on your browser). The default name is in the format: <software version>_<hardware serial number>_<date>_<time>_backup.tar.gz. (The file extension is normally .tar.gz.enc if an encryption password is specified. However, if you use Internet Explorer to create an encrypted backup file, the filename extension will be .tar.gz.gz by default. These different filename extensions have no operational impact; you can create and restore encrypted backup files using any supported browser.)
The preparation of the system backup file may take several minutes. Do not navigate away from this page while the file is being prepared.
5. Save the file to a designated location.
Log files are not included in the system backup file.

Restoring a previous backup -
To restore the Expressway to a previous configuration of system data:
1. Go to Maintenance > Backup and restore.
2. In the Restore section, Browse to the backup file containing the configuration you want to restore.
3. In the Decryption password field, enter the password that was used to create the backup file, or leave it blank if the backup file was created without a password.
4. Click Upload system backup file.
5. The Expressway checks the file and takes you to the Restore confirmation page.
✑ If the backup file is not valid or an incorrect decryption password is entered, you will receive an error message at the top of the Backup and restore page.
✑ You are shown the current software version and the number of calls.
6. Read all the warning messages that appear before proceeding with the restore.
7. Click Continue with system restore to continue with the restore process.
This will restart your system, so ensure that there are no active calls.
After the system restarts, you are taken to the Login page.

by [deleted] at April 3, 2025, 8:21 a.m.

Comments

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!