Exam 210-065 topic 5 question 149 discussion

Actual exam question from Cisco's 210-065

Question #: 149
Topic #: 5

What is the proper procedure to manually reset a password on a Cisco TelePresence EX Series endpoint running software version TC7?

A. Use SSH to access the device and use the username "cisco" and the password "TANDBERG."
B. Hold down the mute key on the touch display for 25 seconds and reset the password using the touch screen.
C. When the device is powered down, hold down the power button until the power light blinks twice, then press the power button twice.
D. Tap the power button four times within ten seconds and then use Telnet to connect to the device IP address.
E. Tap the power button five times while the device is powered off and when it boots, use Telnet to connect to the device within 60 seconds.

Show Suggested Answer

Suggested Answer: C 🗳️
Resetting the EX90 to factory settings:
1. Unplug the power cable.
2. Replug the power cable.
3. Press and hold the power button immediately when the green LED in the bottom left corner lights up. Hold until the LED turns off and on again after approximately 10 seconds.
4. Release the power button, and press it twice within 2 seconds.
The TANDBERG EX90 is now reset to factory defaults.
A factory reset can also be performed by executing a single API command.
Log into the TANDBERG EX90 as admin using SSH (Secure Shell):
1. Execute the API command: xCommand systemunit FactoryReset Confirm: Yes
2. The system will now reboot
The procedure will reset or delete:
✑ All passwords to factory default
✑ All configurations to factory default, including SIP and H.323 settings
✑ Local phonebook
✑ All logs

DHCP-information -

The procedure will not delete software release - and option keys.
Reference:
http://www.cisco.com/c/en/us/support/docs/collaboration-endpoints/telepresence-system-ex90/112501-pqa-112501-00.html

by [deleted] at April 3, 2025, 8:32 a.m.

Comments

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!