ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-070 All Questions

View all questions & answers for the 300-070 exam
Go to Exam

Exam 300-070 topic 1 question 129 discussion

Actual exam question from Cisco's 300-070
Question #: 129
Topic #: 1
[All 300-070 Questions]

Refer to the exhibit.

An engineer is working on a ticket that reports TEL1 cannot call TEL2. These dial peers are configured to route the call between the endpoints. dial-peer voice 2001voip destination-pattern 2001 session protocol sipv2 session target ipv4:10.1.1.2 incoming called-number . codec g722-64 video codec h264 dtmf-relay rtp-nte sip-notify sip-kpml no vad dial-peer voice 3001 voip destination-pattern 3001 session protocol sipv2 session target ipv4:10.3.1.2 incoming called-number . codec g722-64 video codec h264 dtmf-relay rtp-nte sip-notify sip-kpml no vad
While troubleshooting, the engineer discovers that the Cisco Unified Border Element is giving the error "SIP/2.0 403 Forbidden". Which two Cisco Unified Border
Element configurations resolve this issue? (Choose two.)

  • A. voice service voip mode border-element ip address trusted list ipv4 10.1.1.0 255.255.255.0 ipv4 10.2.1.0 255.255.255.0 allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
  • B. voice service voip no ip address trusted authenticate mode border-element allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
  • C. voice service voip mode border-element ip address trusted list allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
  • D. voice service voip mode border-element allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
  • E. voice service voip mode border-element ip address trusted list ipv4 10.1.1.0 255.255 255.0 ipv4 10.3.1.0 255.255.255.0 allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
Show Suggested Answer Hide Answer
Suggested Answer: BE 🗳️
by [deleted] at April 3, 2025, 2:55 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel