ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 400-351 All Questions

View all questions & answers for the 400-351 exam
Go to Exam

Exam 400-351 topic 1 question 134 discussion

Actual exam question from Cisco's 400-351
Question #: 134
Topic #: 1
[All 400-351 Questions]

Refer to the exhibit.
You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode, the AP will not rejoin the Cisco WLC. Which debug command was run, according to the exhibit, and why is the AP not rejoining the Cisco WLC?

  • A. debug capwap packet was run, and 3500e APs do not support indoor mesh.
  • B. debug pm pki was run, and you must disable VLAN transparent for 3500e indoor mesh deployments.
  • C. debug mesh security was run, and the 3500e radio MAC address is not in the local MAC filter list on the Cisco WLC.
  • D. debug ap join was run, and you must disable VLAN transparent for 3500e indoor mesh deployments.
  • E. debug capwap events enable was run, and the 3500e Ethernet MAC address is not in the local MAC filter list on the Cisco WLC.
Show Suggested Answer Hide Answer
Suggested Answer: E 🗳️
by kidschannel1988 at April 4, 2025, 1:10 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel