Exam 200-301 topic 1 question 193 discussion

Actual exam question from Cisco's 200-301

Question #: 193
Topic #: 1

[All 200-301 Questions]

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

A. lldp timer
B. lldp tlv-select
C. lldp reinit
D. lldp holdtime

Show Suggested Answer

Suggested Answer: C 🗳️
ג€¢ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it
ג€¢ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface
ג€¢ lldp timer rate: Set the sending frequency of LLDP updates in seconds
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swlldp.html

by ansari at May 7, 2020, 11:48 a.m.

Comments

Submit Cancel

Ettmoh

Highly Voted 4 years, 2 months ago

(config)#lldp ? holdtime Specify the holdtime (in sec) to be sent in packets reinit Delay (in sec) for LLDP initialization on any interface run Enable LLDP timer Specify the rate at which LLDP packets are sent (in sec) tlv-select Selection of LLDP TLVs to send

upvoted 25 times

...

karemAbdullah

Highly Voted 4 years, 1 month ago

lldp reinit Specifies the delay time in seconds for LLDP to initialize on any interface. The range is 1 to 10 seconds; the default is 2 seconds.

upvoted 17 times

...

[Removed]

Most Recent 7 months, 3 weeks ago

Selected Answer: C

it´s C

upvoted 2 times

...

ZUMY

2 years, 5 months ago

C is correct

upvoted 4 times

...

Exam 200-301 All Questions

View all questions & answers for the 200-301 exam