Exam 350-801 topic 1 question 153 discussion

Should be A

have never seen "auto-config" for a gwy

If you would like the gateway to download much of its MGCP configuration from CallManager, you must code that and give it the IP address or DNS name for the TFTP server (usually CallManager). This downloads XML files with configuration such as MGCP packages, RTP settings, and fax settings. The commands to enable this are as follows: VoiceGW(config)#ccm-manager config server {ip-address | dns-name} VoiceGW(config)#ccm-manager config This file is downloaded when the gateway first communicates with CallManager, before it sends the RSIP message. The file is refreshed if changes are made to CallManager that require the gateway to be reset. Cisco Voice Gateways and Gatekeepers Chapter 2: Media Gateway Control Protocol

Correct answer is A.

Definitely go with A

Correct answer is A.

auto-configuration doesn't exists.. answer is A

Should be A

Answer is A. to have the CUCM control the MGCP Gateway, you need "ccm-manager configuration"

B) custom config from TFTP I am going with B based on this article, after defining MGCP gateway in CUCM, you then enter the ccm-manager config commands. See 'Figure 1G-S MGCP Configuration Server Communication' https://www.ccexpert.us/cisco-unified/mgcp-configuration-server.html See text "Step 6 Click Save. Reset the gateway for configuration changes to be committed to the gateway" Thinking about my experience with MGCP gateways, there are a number of parameters that I configure on CUCM & not on the gateway.

we cannot configure mgcp on auto configure on the cucm ; all parameter has to be set manually , so A is correct

my guess is A

It is A

Correct answer is letter A

Correct answer is A