This question is very vague.
It could also be asking how to change between primary / backup image. In that case it would be "Config boot [Primary /Backup]"
(Cisco Controller) >config boot ?
primary Sets the primary image as active.
backup Sets the backup image as active.
Not sure where this question is going.
To change between the primary and backup images on a WLC, the command from CLI is:
"config boot [primary/backup]"
To download a new Image for the WLC, you can use either FTP or TFTP protocols,
and the command is:
"transfer download start"
Here is an example:
(Cisco Controller) >transfer download datatype code
(Cisco Controller) >transfer download mode ftp
(Cisco Controller) >transfer download username admin
(Cisco Controller) >transfer download password ********
(Cisco Controller) >transfer download serverip 192.168.1.2
(Cisco Controller) >transfer download path /Shared/AIR-CT3504/
(Cisco Controller) >transfer download filename AIR-CT3504-K9-8-8-111-0.aes
(Cisco Controller) >transfer download start <<<<<
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.200-355 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
xtrattitude4u
5 years, 10 months agoxtrattitude4u
5 years, 10 months ago