ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 210-065 All Questions

View all questions & answers for the 210-065 exam
Go to Exam

Exam 210-065 topic 5 question 196 discussion

Actual exam question from Cisco's 210-065
Question #: 196
Topic #: 5
[All 210-065 Questions]

An engineer is configuring the brightness on a Cisco SX10 endpoint with default configuration via the CLI with the xConfiguration Cameras Camera 1 Brightness
Level: 1 command but notices no changes to the local display brightness level. Which option is the reason for this issue?

  • A. The codec must be rebooted for the changes to take effect.
  • B. The display brightness was changed from the remote end.
  • C. The default brightness level is 1.
  • D. The brightness mode must be set to manual.
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by AH at Feb. 17, 2019, 7:08 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
AH
Highly Voted 5 years, 9 months ago
The brightness mode must be set to manual.
upvoted 5 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago