Exam 300-365 topic 1 question 37 discussion

Actual exam question from Cisco's 300-365

Question #: 37
Topic #: 1

[All 300-365 Questions]

Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)

A. If Ethernet and wireless are available, it attempts to discover only via Ethernet.
B. If Ethernet is disconnected, it attempts to connect wirelessly using AWPP.
C. If only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC.
D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
E. If Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.

Show Suggested Answer

Suggested Answer: AB 🗳️
References: http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-3/configuration/guide/b_cg73/b_wlc-cg_chapter_01001.html

by wlan_admin at Aug. 12, 2019, 11:55 p.m.

Comments

Submit Cancel

wlan_admin

5 years, 10 months ago

Perhap B and D are correct. Answer A. contains the word only. A MAP always sets the Ethernet port as the primary backhaul if it is UP, and secondarily the 802.11a/n radio. This gives the network administrator time to reconfigure the mesh access point as a RAP, initially. For faster convergence on the network, we recommend that you do not connect any Ethernet device to the MAP until it has joined the mesh network. A MAP that fails to connect to a controller on a UP Ethernet port, sets the 802.11a/n radio as the primary backhaul. If a MAP fails to find a neighbor or fails to connect to a controller through a neighbor, the Ethernet port is set as the primary backhaul again.

upvoted 1 times

...