Exam 300-715 topic 1 question 73 discussion

I believe this the correct answer should be D : https://www.packetmischief.ca/2012/02/09/cisco-ise-and-ip-http-server/

D) SISE ebook: "Enable the Switch HTTP/HTTPS Server The embedded HTTP/HTTPS server in IOS is used to grab HTTP traffic from the user and redirect that user’s browser to the Centralized Web Authentication portal or to a device registration portal or even to the mobile device management onboarding portal. This same function is used for redirecting the posture agent’s traffic to the Policy Services node. Follow these steps to enable the switch HTTP/HTTPS server: Step 1. Enable the HTTP server by entering the following command in global configuration mode: C3850(config)# ip http server Step 2. Enable the HTTP secure server by entering the following command: C3850(config)# ip http secure-server"

The purpose of the ip http server command on a switch is to enable the https server for users for web authentication. This means that when a user connects to the switch, they will be redirected to a web page where they can enter their username and password. If the username and password are correct, the user will be granted access to the network. The other options are incorrect. dot1x authentication is a type of Layer 2 authentication that uses 802.1X. It is not enabled by the ip http server command. MAB authentication is a type of Layer 2 authentication that uses MAC addresses. It is not enabled by the ip http server command. The switch does not redirect users for web authentication. The user is redirected to the web page by the switch's HTTP server.

D is correct

D, allows redirect

Answer is D. If you missed this, stop here and go back to study.

D is needed for web redirect

It's the DDDDDDDDD For Mab you use command :Mab on NAD

D is correct

the Purpose as the questions mentioned is to redirect users for web authentication. the correct answer is D

correct answer is D but the question is written in a poor manner...

Correct answer is D.