A.
The PPPoE client does not support the following:
• More than ten clients per customer premises equipment (CPE)
• Quality of service (QoS) transmission with queueing on the dialer interface
• Dial-on-demand
• Easy VPN
• Native IPv6
• PPPoE client over ATM permanent virtual circuit (PVC)
• You can configure a dial-pool-number on a physical interface or sub-interface using the pppoe-client
dial-pool-number pool-number command.
Note The pool number being unique cannot be used to configure with the same number on any other interfaces.
• Co-existence of the PPPoE client and server on the same device.
• Multilink PPP (MLP) on dialer interfaces
• Nonstop forwarding (NSF) with stateful switchover (SSO)
• When an IPv6 address is assgined to a subinterface from a server and if you remove the subinterface on client device, the IPv6 address might not be removed from the interface resulting in a ping failure after reconfiguring the subinterface. This is because you must shut the interface, first and then remove the subinterface.
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/bbdsl/configuration/xe-16-11/bba-xe-16-11-book/bba-pppoe-client-xe.pdf
upvoted 5 times
...
This section is not available anymore. Please use the main Exam Page.300-101 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
Bastex
Highly Voted 5 years, 9 months ago