Exam 300-415 topic 1 question 74 discussion

yes B is the right answer sdwan nterface interface-name tunnel-interface tloc-extension-gre-to extended-interface-ip-address

B is correct - the rest aren't valid commands: vedge(config-vpn-0)# int g0/0 vedge(config-interface-g0/0)# gre-interface ------------------------------^ syntax error: unknown command vedge(config-interface-g0/0)# extended-interface ------------------------------^ syntax error: unknown command vedge(config-interface-g0/0)# tloc-interface ------------------------------^ syntax error: unknown command vedge(config-interface-g0/0)# tunnel-interface vedge(config-tunnel-interface)#

B is the correct answer

B is correct

it should be B

Bis correct

They worded the question badly. They ask which config is used to extend TLOC to another router. Worded that way, no answer is correct. Option B is the only answer without fake syntax, so it must be correct. But option B is not the config on the router that is extending the TLOC. It is the config on the other router, that the TLOC is being extended to. Still, the other answers are wrong on either router because they have fake syntax.

Correct B vManage Feature Template For Cisco IOS XE routers only: Configuration ► Templates ► VPN Interface Ethernet Command Hierarchy sdwan interface interface-name tunnel-interface tloc-extension-gre-to extended-interface-ip-address

Yes B is correct answer https://www.cisco.com/c/en/us/support/docs/routers/sd-wan/220333-configure-layer-3-tloc-extension.html

B is correct : Configure a tunnel interface over which to run TLOC extensions (on IOS XE routers only). TLOC extensions allow you to extend a TLOC, over a GRE tunnel, to another router in the branch. sdwan interface interface-name tunnel-interface tloc-extension-gre-to extended-interface-ip-address https://www.cisco.com/c/en/us/td/docs/routers/sdwan/command/sdwan-cr-book/config-cmd.html#r_tloc_extension_gre_to_11940.xml

B is the right one

Correct answer is B. cEdge-4(config)# sdwan cEdge-4(config-sdwan)# interface GigabitEthernet2 cEdge-4(config-interface-GigabitEthernet2)# tunnel-interface cEdge-4(config-tunnel-interface)# tloc-extension-gre-to

correct answer is B

B is correct

I think tunnel-interface is the only command possible, which easily eliminates other options. So it's B.

B. Correct Link: https://www.cisco.com/c/en/us/td/docs/routers/sdwan/command/sdwan-cr-book/sdwan-cr-book_chapter_010.html#wp2314758100 sdwan interface tloc-extension-gre-to—Configure a tunnel interface over which to run TLOC extensions (on IOS XE routers only). TLOC extensions allow you to extend a TLOC, over a GRE tunnel, to another router in the branch. sdwan interface tloc-extension-gre-from —Configure an interface as an extended interface, to channel TLOC traffic from a source branch router to the local WAN interface (on IOS XE routers only).

Also agree with B