Exam 200-301 topic 1 question 520 discussion

stop confusing people the answer is correct R2#show ip int gi0/0/0 GigabitEthernet0/0/0 is up, line protocol is up (connected) Internet address is 10.1.0.2/24 Broadcast address is 255.255.255.255 Address determined by DHCP MTU is 1500 bytes

D is correct

just test it in PT... answer is D

let me guess. both d and e are correct but d is cisco's best practice so it's more correct

Yes "show ip int brief" will show if address is configured manually but so can "show ip interface g0/0".

the command is telling me "Address is determined by setup command" And dhcp is working fine in network

Router#sh ip int g0/0 GigabitEthernet0/0 is up, line protocol is up (connected) Internet address is 10.0.0.11/24 Broadcast address is 255.255.255.255 Address determined by DHCP MTU is 1500 bytes

Correct Answer should be E i have done a test and test result as below We have a small network consisting of a router and a DHCP server. We want to configure the interface Gi0/0 on the router as a DHCP client. This is how this is done: R1(config)#int Gi0/0 R1(config-if)#ip address dhcp We can verify that the Gi0/0 interface has indeed got its IP address from the DHCP server by running the show ip int brief command: R1#show ip int brief Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0 192.168.0.1 YES DHCP up up GigabitEthernet0/1 unassigned YES unset administratively down down The DHCP keyword in the method column indicates that the IP information were obtained by the DHCP server.

I don't know why people say no one is correct...Instead Answer D is working for me in PT. With "show ip interface <interface>" the output shows the IP address is either determined by DHCP or setup command (manually): R2#show ip int brief Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0/0 10.1.0.2 YES DHCP up up GigabitEthernet0/0/1 10.2.0.1 YES manual up down GigabitEthernet0/0/2 unassigned YES unset administratively down down Vlan1 unassigned YES unset administratively down down R2#show ip int gi0/0/0 GigabitEthernet0/0/0 is up, line protocol is up (connected) Internet address is 10.1.0.2/24 Broadcast address is 255.255.255.255 Address determined by DHCP MTU is 1500 bytes ... R2#show ip int gi0/0/1 GigabitEthernet0/0/1 is up, line protocol is down (disabled) Internet address is 10.2.0.1/24 Broadcast address is 255.255.255.255 Address determined by setup command MTU is 1500 bytes ...

There is no correct answer on this one (should be: show ip interface brief).

D because "show ip interface" show's all of the settings that are IP specific. You can see in the example code they provide on the website below that ip helper address is listed under the "show ip interface" command. https://www.ciscopress.com/articles/article.asp?p=1829350

no one. sh ip interface brif will show you Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0 unassigned YES DHCP up up

what about B?

What's the difference between "show interface" and "show ip interface"?