Exam 300-535 topic 1 question 21 discussion

It is using dial-out, not dial-in. therefore A. https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-4/telemetry/configuration/guide/b-telemetry-cg-asr9000-74x/dial-out-telemetry-session-from-router-to-destination.html

The correct answer is A. The router cannot establish a gRPC connection with the collector. Here's a breakdown of the evidence supporting this conclusion: Key Clues: "NA" (Not Applicable) State for Subscription and Destination Group: This indicates an issue with establishing the telemetry connection. Transport=gRPC: The configuration specifies gRPC for communication, which means the router expects to initiate a gRPC connection with the collector. Sensor Group State=Resolved: This suggests that the YANG path is valid, but the connection itself is not established.

Sensor group is Resolved, B is incorrect. Destination group state is NA, dial-out must be configured, so I vote for A

An Active state indicates that the router is ready to stream data to the receiver based on the subscription

the state changes to active once the collector dial in https://www.linkedin.com/pulse/using-advanced-netconf-explorer-anx-syed-hassan/

Sorry. D is not correct. It is A the answer.

D is the answer for sure.

A is the answer as DG state is not Active

Looks like Active and NA state are same , Use the following command to verify that you have correctly configured the router for gRPC dial-out. RP/0/RP0/CPU0:SunC#show telemetry model-driven subscription Thu Jul 21 21:14:08.636 UTC Subscription: Sub2 State: ACTIVE ------------- Sensor groups: Id Interval(ms) State SGroup2 30000 Resolved Destination Groups: Id Encoding Transport State Port IP DGroup2 self-describing-gpb grpc NA 57500 172.30.8.4

As I think, the answer is 'A'

The correct answer is: D https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/telemetry/b-telemetry-cg-asr9000-62x/b-telemetry-config-guide-asr9000_chapter_01.html