exam questions

Exam 200-301 All Questions

View all questions & answers for the 200-301 exam

Exam 200-301 topic 1 question 549 discussion

Actual exam question from Cisco's 200-301
Question #: 549
Topic #: 1
[All 200-301 Questions]

Where does the configuration reside when a helper address is configured lo support DHCP?

  • A. on the router closest to the server
  • B. on the router closest to the client
  • C. on every router along the path
  • D. on the switch trunk interface
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
shakyak
Highly Voted 3 years, 7 months ago
It's a helper so closest to the client.
upvoted 14 times
...
gaber
Highly Voted 3 years, 5 months ago
a router, being a device that communicates with other networks, the client-being the source generating the request, and the server being the dhcp server on the destination lan. the router with the helper-address configured(which is on the local network) will turn the broadcast traffic into unicast traffic, after which any device it hits will see it as unicast, not needing any further configuration. thus, we're looking at B https://networkengineering.stackexchange.com/questions/41376/how-ip-helper-address-works https://community.cisco.com/t5/routing/forwarding-udp-broadcast-traffic/td-p/595108 https://community.cisco.com/t5/switching/broadcast-traffic-on-router/td-p/751300
upvoted 6 times
...
mici
Most Recent 7 months, 1 week ago
Let's look at question #530
upvoted 3 times
...
[Removed]
1 year, 3 months ago
Selected Answer: B
B is correct
upvoted 1 times
...
a67c04a
1 year, 4 months ago
Selected Answer: B
It´s B
upvoted 2 times
...
NSA_Poker
1 year, 6 months ago
Selected Answer: A
EXAM 200-301 TOPIC 1 QUESTION 530 DISCUSSION (see exhibit) The ip helper is on R2 (closest to the DHCP server). The client is on R1. In DHCPv4 (IPv4 addressing), you configured the IP Helper feature on Cisco routers when the DHCP server was NOT ON THE SAME SEGMENT AS THE REQUESTING CLIENTS. -All in One CCT/CCNA Routing and Switching.
upvoted 3 times
NSA_Poker
1 year, 4 months ago
gaber's comment about broadcast vs unicast made sense and changed my mind. The correct answer is B.
upvoted 2 times
...
...
Yinxs
1 year, 10 months ago
Selected Answer: B
Because client send DHCP request packet to the helper by broadcast, so client and helper must be in the same subnet, they are very close. By contrast, helper router forward the request to the DHCP server by nuicast, which is routable. So the DHCP server can be far away to the helper.
upvoted 2 times
...
justajoke
1 year, 11 months ago
Why do they word the questions this way? I know the answer, the hard part is figuring out what the hell the question is.
upvoted 4 times
...
[Removed]
2 years, 8 months ago
Selected Answer: B
The answer is B
upvoted 4 times
...
bwg
4 years ago
Can someone explain it?
upvoted 2 times
Sten111
3 years, 12 months ago
This explains it pretty well https://www.ciscopress.com/articles/article.asp?p=330807&seqNum=9
upvoted 3 times
...
dave1992
3 years, 8 months ago
I can explain, By default routers don’t forward broadcast traffic so the ip helper config will need to be applied on every interface towards the client. This means if you have 2 routers between a DHCP server and a client, the helper config will need to be on BOTH routers. C is actually the correct answer, B works for 1 scenario, C works for all scenarios
upvoted 9 times
[Removed]
2 years, 8 months ago
B is the correct answer in all scenarios. You only need to configure ip helper address on the closet router to the client. Then you would need to make sure that an ip route exists between the dhcp server and that router that is acting as a dhcp helper
upvoted 2 times
FALARASTA
2 years, 1 month ago
There is no need to configure two routers along the way as dhcp helpers because the one closest to the client chnages the broadcast to a unicast request automatically
upvoted 3 times
...
...
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
Loading ...