ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 200-105 All Questions

View all questions & answers for the 200-105 exam
Go to Exam

Exam 200-105 topic 1 question 468 discussion

Actual exam question from Cisco's 200-105
Question #: 468
Topic #: 1
[All 200-105 Questions]

Which value must you configure on a device before EIGRP for IPv6 can start running?

  • A. public IP address
  • B. loopback interface
  • C. router ID
  • D. process ID
Show Suggested Answer Hide Answer
Suggested Answer: C 🗳️
by Quan at Sept. 20, 2019, 2:15 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Quan
5 years, 9 months ago
The answer is C (Router ID). Explanation: https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/113267-eigrp-ipv6-00.html The configuration of EIGRP for IPv6 has some restrictions; which are: The interfaces can be directly configured with EIGRP for IPv6, without the use of a global IPv6 address. There is no network statement in EIGRP for IPv6. The router ID needs to be configured for an EIGRPv6 protocol instance before it can run. EIGRP for IPv6 has a shutdown feature. Ensure that the routing process is in "no shut" mode in order to run the protocol.
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel