Exam 200-105 topic 1 question 405 discussion

Actual exam question from Cisco's 200-105

Question #: 405
Topic #: 1

[All 200-105 Questions]

Which two values are needed to run the APIC-EM ACL Analysis tool? (Choose two.)

A. destination port
B. source address
C. protocol
D. source port
E. periodic refresh interval
F. destination address

Show Suggested Answer

Suggested Answer: DF 🗳️

by Quan at Sept. 30, 2019, 11:50 a.m.

Comments

Submit Cancel

Quan

5 years, 9 months ago

Link for explanation: https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/application-policy-infrastructure-controller-enterprise-module/1-4-x/path_trace/user-guide/b_Cisco_Path_Trace_User_Guide_1_4_0_x/b_Cisco_Path_Trace_Solution_Guide_1_4_0_x_chapter_011.html

upvoted 1 times

darratt

5 years, 5 months ago

I agree with QUAN URL Link In the Source field, enter the IP address of the host or the Layer 3 forwarding interface where you want the trace to start. In the Destination field, enter the IP address of the host or Layer 3 forwarding interface where you want the trace to end. You can also enter an IP address of an unmanaged device (called an unknown destination). Step 5 (Optional)To configure source and destination ports or protocols, click More Options. Step 6 (Optional)In the Source Port field, enter the port number of the host where you want the trace to end. Step 7 (Optional)In the Destination Port field, enter the port number of the host where you want the trace to end. Step 8 (Optional)In the Protocol field, choose tcp or udp from the drop-down menu for the Layer 4 path trace protocol. Step 9 (Optional)To configure the path trace to refresh every 30 seconds, check the Periodic Refresh (30 sec) check box. Step 10 (Optional)To configure the path trace to collect additonal statistics, check the Stats check box and any of the following check boxes, as desired:

upvoted 1 times

...

Quan

5 years, 9 months ago

The answer should be B and F. Source port and destination port are OPTIONAL. Explanation: Step 1 In the Navigation pane, click Path Trace. Step 2 From the path trace toolbar, click Start new Path Trace. Step 3 In the Source field, enter the IP address of the host or the Layer 3 forwarding interface where you want the trace to start. If you enter the device IP address manually, you need to select the device from the list and then the interfaces for that device. Step 4 In the Destination field, enter the IP address of the host or Layer 3 forwarding interface where you want the trace to end. You can also enter an IP address of an unmanaged device (called an unknown destination). If you enter the device IP address manually, you need to select the device from the list and then the interfaces for that device. Step 5 (Optional)To configure source and destination ports or protocols, click More Options. Step 6 (Optional)In the Source Port field, enter the port number of the host where you want the trace to end. Step 7 (Optional)In the Destination Port field, enter the port number of the host where you want the trace to end.

upvoted 2 times

...