Exam 300-435 topic 1 question 48 discussion

Actual exam question from Cisco's 300-435

Question #: 48
Topic #: 1

Refer to the exhibit. The configuration commands are entered in CLI config mode to configure a static telemetry subscription on a Cisco IOS XE device. The commands are accepted by the device, but the consumer receives no telemetry data. Which change must be made to ensure that the consumer receives the telemetry data?

A. The IP address of the receiver must be set.
B. The stream type must be set to YANG.
C. The update policy period must be shortened.
D. The sender IP address must be set.

Show Suggested Answer

Suggested Answer: B 🗳️
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/1610/b_1610_programmability_cg/model_driven_telemetry.html

by Laith_A at Oct. 29, 2021, 3:29 p.m.

Comments

Submit Cancel

Laith_A

Highly Voted 2 years, 2 months ago

A. The IP address of the receiver must be set.

upvoted 12 times

...

cj_kuo

Most Recent 11 months, 1 week ago

Selected Answer: A

Answer was A, refer https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/176/b_176_programmability_cg/m_176_prog_ietf_telemetry.html#id_90962

upvoted 1 times

...

pafcio84

1 year, 1 month ago

Must be defined IP of collector.

upvoted 1 times

...

Lyndongarcia09

1 year, 11 months ago

Answer is A https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/167/b_167_programmability_cg/model_driven_telemetry.html

upvoted 3 times

...

NoobChampion

1 year, 11 months ago

tldr: A long version: I think A should be the right answer. If you check the reference link yang-push and periodic 6000 are valid options. Sender IP could be any configured interface, but receiver IP has to be configured.

upvoted 3 times

...