Exam 300-135 topic 9 question 3 discussion

Actual exam question from Cisco's 300-135

Question #: 3
Topic #: 9

The implementations group has been using the test bed to do a "˜proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at
209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
The fault condition is related to which technology?

A. Under the global configuration mode enter no access-list 10 command.
B. Under the global configuration mode enter no access-map vlan 10 command.
C. Under the global configuration mode enter no vlan access-map test1 10 command.
D. Under the global configuration mode enter no vlan filter test1 vlan-list 10 command.

Show Suggested Answer

Suggested Answer: C 🗳️
On DSW1, VALN ACL, Need to delete the VLAN access-map test1 whose action is to drop access-list 10; specifically 10.2.1.3

by Fiss at Oct. 15, 2019, 11:01 a.m.

Comments

Submit Cancel

Fiss

Highly Voted 5 years, 8 months ago

the correct answer is D

upvoted 5 times

james

5 years, 6 months ago

I disagree, correct answer is C. We're only meant to be fixing the one client's ping issue, in which case we only need to remove entry 10 from the test1 route map which is used in the vlan filter. The rest of the route map doesn't block that client from reaching the server.

upvoted 1 times

...

Sk123456789

Most Recent 5 years, 5 months ago

This is a typical Cisco exam question, far too open to interpretation but I have to agree with James - correct answer is C. The question clearly states "a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address" - it doesn't mention Client 2 at all. IMO we shouldn't assume Client 2 has to be fixed even though the question's scenario/description suggests it would be affected by the same issue as Client 1. Of course that's only an opinion. Anyone out there get this question in the exam and get a 100% pass? If so, what was their answer?

upvoted 2 times

...

Roysons

5 years, 5 months ago

"The implementations group has been using the test bed to do a "˜proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241" Therefore, we should consider client 2 should be able to access to WEB Server. The correct answer is D.

upvoted 3 times

...