Exam 300-430 topic 1 question 62 discussion

Actual exam question from Cisco's 300-430

Question #: 62
Topic #: 1

The Cisco Hyperlocation detection threshold is currently set to -50 dBm. After reviewing the wireless user location, discrepancies have been noticed. To improve the Cisco Hyperlocation accuracy, an engineer attempts to change the detection threshold to -100 dBm. However, the Cisco Catalyst 9800 Series Wireless
Controller does not allow this change to be applied. What actions should be taken to resolve this issue?

A. Disable Cisco Hyperlocation, change the Cisco Hyperlocation detection threshold, and then enable it.
B. Create a new profile on Cisco CMX with the new Cisco Hyperlocation detection range, and apply it on the WLAN.
C. Place the APs to monitor mode, shutdown the radios, and then change the Cisco Hyperlocation detection threshold.
D. Shutdown all radios on the controller, change the Cisco Hyperlocation detection range, and enable the radios again.

Show Suggested Answer

Suggested Answer: A 🗳️

by kthekillerc at Dec. 29, 2021, 9:48 p.m.

Comments

Submit Cancel

Guglielmino

Highly Voted 3 years, 3 months ago

In your document https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-1/config-guide/b_wl_17_11_cg/cisco-hyperlocation.html: "Restrictions on Cisco Hyperlocation It is not possible to modify detection, trigger, and reset thresholds while Hyperlocation is in enabled state." So the correct answer is A

upvoted 17 times

...

rrahim

Most Recent 4 months ago

Selected Answer: A

A. Disable Cisco Hyperlocation, change the Cisco Hyperlocation detection threshold, and then enable it. To change the Cisco Hyperlocation detection threshold on a Cisco Catalyst 9800 Series Wireless Controller, you must first disable Cisco Hyperlocation, make the necessary changes, and then re-enable it. This is because certain settings, like the detection threshold, cannot be modified while Hyperlocation is active.

upvoted 1 times

...

riktammenaars

8 months ago

Selected Answer: A

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-1/config-guide/b_wl_17_11_cg/cisco-hyperlocation.html#restrictions-on-hyperlocation

upvoted 1 times

...

Ocsicccnp

8 months, 3 weeks ago

Selected Answer: A

It is not possible to modify detection, trigger, and reset thresholds while Hyperlocation is in enabled state.

upvoted 1 times

...

JimDiGriz

2 years, 2 months ago

Selected Answer: A

It is not possible to modify detection, trigger, and reset thresholds while Hyperlocation is in enabled state.

upvoted 2 times

...

kthekillerc

3 years, 4 months ago

Selected Answer: B

Believe answer should be B

upvoted 2 times

anonymonkey

3 years, 3 months ago

Think you were right the first time. https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-1/config-guide/b_wl_17_11_cg/cisco-hyperlocation.html

upvoted 4 times

...

kthekillerc

3 years, 6 months ago

Provided answer is correct

upvoted 1 times

...