Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R1. Which solution should the design include?
A.
Use update-source to specify the Loopback interface.
B.
Use next-hop-self attributes only for routes that are learned from eBGP peers.
C.
Configure the eBGP TTL to support eBGP multihop.
D.
Use maximum-paths to install multiple paths in the routing table.
D. Use maximum-paths to install multiple paths in the routing table: This configuration allows multiple paths to be installed in the routing table for the same destination prefix, enabling load sharing between R1 and R6. By using the maximum-paths command, traffic can be load balanced between the two routers, optimizing bandwidth utilization.
C is the correct answare. R6 wants two bgp sessio to R1, one of direct other is not. Therefore second session is not able to succes becouse of BGP ttl=1. You have to setting ebgp-multihop .
https://networklessons.com/bgp/ebgp-multihop
This section is not available anymore. Please use the main Exam Page.300-420 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
SpicyMochi
6 months, 1 week agokonyuz
9 months agovallzo
2 months agoXalaGyan
1 year, 7 months ago