Exam 300-425 topic 1 question 60 discussion

Actual exam question from Cisco's 300-425

Question #: 60
Topic #: 1

A customer called with a requirement that internal clients must be on different subnets depending on the building they are in. All APs are operating in local mode and will not be modified, and this is a single controller solution. Which design approach creates the desired result?

A. Create FlexConnect groups, place the access points in, and set the correct VLAN to SSID mapping based on location.
B. Create mobility anchors for the SSID, and on the controller under the internal SSID, create a foreign map to the desired VLAN based on location.
C. Create AP groups for each desired location, map the correct VLANs to the internal SSID, and add the APs for that location.
D. Create an SSID, place it to the desired VLAN under WLANs, and configure 802.1x in ISE to assign the correct VLAN based on the SSID from which the client is authenticating.

Show Suggested Answer

Suggested Answer: C 🗳️

by HealthyGeneral at April 22, 2022, 12:12 p.m.

Comments

Submit Cancel

Farhad123

9 months ago

Also read this for more clarification regarding AP group: https://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/emob30dg/TechArch.html

upvoted 1 times

...

Alonzo_Harris

2 years, 6 months ago

Selected Answer: C

The answer is definitely C. I have done this many times throughout the hospital.

upvoted 4 times

...

HealthyGeneral

3 years, 2 months ago

Answer is A. From https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-7/config-guide/b_cg87/flexconnect_groups.html "All of the FlexConnect APs in a group can share the same backup RADIUS server, fast secure roaming, local authentication configuration, and WLAN-VLAN mapping information." So flex connect groups are set up for each building, aps within that building are put into the corresponding group, the flex connect group has VLAN settings specific for that building.

upvoted 1 times

HealthyGeneral

3 years, 1 month ago

I'm 3 hours from the exam. I now believe my comment above is incorrect. (I'm only human! :) The question clearly says, the APs won't be changed from Local Mode, so they can't participate in FlexConnect Groups as that requires a mode change from Local on the APS. I'm still not sure about the answer, but mobility anchors need more than one controller, and who knows if this customer has ISE? So I think the displayed answer is correct, C.

upvoted 9 times

...